7300

Application
Comprised of 3⁄4″ male NPTF Junior gauges designed for use in DOT lift truck cylinders. Also suitable for use in certain recreational vehicle (RV) applications and as a replacement for 3⁄4″ NPT rotary type gauges up to 45″ [114 mm] in diameter.

General Information & Features
Gauges which accept snap-on Junior dials have 1 3⁄8″ [35] hex wrenching flats. Gauges which accept screw-on Junior dials have 2″ [51] hex wrenching flats.

All dials used on these gauges indicate with limited arc due to size constraints imposed on gauge components which must pass through a 3⁄4″ NPT opening.

Documents
Data Sheet
DS-996 Installation Instructions
MS-516 Threaded Gauge Installation Instructions

Description

Cylinder Type Cylinder Capacity Capacity Diameter Gauge with Screw-On Dial Gauge with Snap-On Dial Support Length Float Length
Universal 20# [9 kg] 12″ ID. [305] 7384-01005 7384-02004 7-1/8″ [181] 5-1/4″ [133]
33-1/2# [15 kg] 7384-01006 7384-02005 12-5/16″ [313]
43-1/2# [20 kg] 7384-01007 7384-02006 19-1/4″ [489]
Vertical 14# [6,4 kg] 9″ ID. [229] 7381-01003 7381-02205 10-3/4″ [273] 4″ [102]
20# [9 kg] 12″ ID. [305] 7381-01002 7381-02206 7-5/16″ [186] 6-7/16″ [163]
Horizontal 20# [9 kg] 7384-01028 5″ [127]
33-1/2# [15 kg]
43-1/2# [20 kg]
60# [27 kg]
60# [27 kg] 14-1/2″ ID. [368] 7384-01029 8-1/2″ [216] 7-3/4″ [197]
100# [45 kg]

General Specifications*

Temperature
Standard range is -40°F to 158°F, -40°C to 70°C.

Shock
Designed for lift truck and portable cylinder service applications.

Vibration
Designed for lift truck and portable cylinder service applications.

Working Pressure
375 psig [25,8 Bar]

Approvals
UL listed for LP Gas service applications.

When Ordering Specify:

1. For standard gauges, use the part number from the lift truck gauge selection chart.
2. For non-standard gauges, state the cylinder type (horizontal or vertical), capacity, diameter, height, mounting location, offset, and furnish tank drawings whenever possible.
3. Furnish riser or recess dimensions if applicable.

To order a replacement gauge, simply furnish the information stamped on one of the flat sections on the side of the gauge head as shown in the example below.

Materials of Construction*

Head
Zinc die casting.

Centershaft Bearings, Gears, & Dial Mounting Screws
Stainless steel.

Support, Centershaft & Float Rod
Tempered aluminum.

Gear Housing
Acetal.

Float Bulb
Nitrile rubber.

Counterweight
Lead.

Magnet
Alnico.

Direct Reading Dials
Ultrasonically welded, hermetically sealed polycarbonate.

*Materials and specifications are subject to change without notice. Pressure ratings subject to change due to temperature and other environmental considerations.

You may also like…